The LD-PD'S PM-DCFL Series 1064nm ps Dual Channel fiber lasers. It is an excellent solution for Industrial Ultra-Fast Laser Processing Applications Solution. The picosecond laser has the typical advantages of traditional fiber laser, namely, small size (shape size: 200 *100 *40mm), no need of thermal management, and high output beam quality (single mode output).
This ultrafast laser has spectral center wavelength at 1064 nm, the repetition frequency is 20-40 MHz, typical pulse width is less than 10ps, and the maximum Peak power of each channel is 300W. Due to the use of special non-linear technology to achieve the equivalent saturable absorber effect, the output pulse not only has high long-term stability, but also can withstand high and low temperature working environment from 0-45 degrees. The laser also has excellent mode-locking self-startup performance. It has achieved 100,000 times of mode-locking self-startup, and most of the startup time is less than 2 seconds.
● Excellent long-term stability
● Operation Temperature：+5～+40℃
● Ultra compact Size, Low power consumption
● Dual Channel Synchronized Output
Tsub=25°C, CW bias unless stated otherwise
Center Wavelength (λc)
Beam quality M2
Dual Ports Output
10 to +50
0 to +60
Testing data and Spectrum
15 Hours Long term Power stability testing
PM980 Fiber Nominal Characteristics and Tolerances
950 – 1100 nm
Mode Field Diameter(Gaussian)
6.6 ± 0.5 µm @ 1550 nm
900 ± 40 nm
● Terahertz Generation
● Optical frequency combs
● Optical sensing
● Optical communication
● Pump source for mid-IR laser
SW△: Spectral Width
F:Fast axis alignment
S:Slow axis alignment
XX: Fiber and Connector Type
PPN= PM 980 fiber+ None
PP= PM 980 fiber + FC/PC
PA= PM 980 fiber + FC/APC
Laser Components Safety
Due to the small size of the Fiber optic module, the box packaging is labeled with the laser radiation hazard symbol and safety warning labels shown below:
Safety and Operating Considerations
The laser light emitted from this laser diode is invisible and may be harmful to the human eye. Avoid looking directly into the fiber when the device is in operation.
CAUTION: THE USE OF OPTICAL INSTRUMENTS WITH THIS PRODUCT INCREASES EYE HAZARD.
Operating the laser Components outside of its maximum ratings may cause device failure or a safety hazard. Power supplies used with this component cannot exceed maximum peak optical power.